OP 16 August, 2022 - 03:01 AM
some expertise in 3d moddeling | Joint btw cylinder and a flat surface
Basically i need to joint a hollow cylinder to a hollow cube the joint needs to be able to be split in half and be able to come lost fairly easy i tried a few desings so far but not allot of luck if any1 is extremely good at this please dm me on disc or tg there in my profile
Will close once i either figured it out or found aome1
Basically i need to joint a hollow cylinder to a hollow cube the joint needs to be able to be split in half and be able to come lost fairly easy i tried a few desings so far but not allot of luck if any1 is extremely good at this please dm me on disc or tg there in my profile
Will close once i either figured it out or found aome1